Molded composite lower and upper front right bulkhead set. 

Molded composite lower and upper front left bulkhead set. 

Molded composite adjustable ball-bearing hub. Set of 4.  

CNC-machined front shock tower made from top-grade 2.5mm thick graphite. Includes multiple shock upper mounting positions. 

Molded composite suspension arm, front lower. Used on either left or right side. 

Molded composite suspension arm, front upper. Used on either left or right side. 

Molded composite right-side steering block. 

Molded composite left-side steering block. 

Molded composite eccentric suspension pin inserts with 2 different offset positions. Set of 4 insert frames allows pins to have entire range of adjustment (+1.5, +0.5, -0.5, -1.5mm). 

Molded composite clips to set front caster adjustment, includes 0.5, 1 and 1.5mm. Set of 2. 

Molded composite front anti-roll bar mount set includes left & right holders and eccentric adjustors. 

Female front anti-roll bar for NT1 is CNC-machined from world-renowned HUDY Spring Steel™. Use with #332450 male front anti-roll bar. 

Male front anti-roll bar for NT1 is CNC-machined from world-renowned HUDY Spring Steel™. Use with #332440 female front anti-roll bar. 

CNC-machined drive axle for NT1 made from world-renowned HUDY Spring Steel™. Used for front or rear with standard drive shafts (not for use with CVD sets). 

CNC-machined front drive shaft (55mm) made from world-renowned HUDY Spring Steel™. Used for FRONT only. Use with #335210 drive axle. 

Strong composite wheel hubs. Set of 2. 

PUR® reinforced front drive belt. 5.0 x 186mm. This belt is very thin and elastic as possible for an extremely efficient, low-friction drivetrain. 

Front lower inner pivot pins for NT1. Hardened for very high durability and long life. Set of 2. 

Front upper inner pivot pins for NT1. Hardened for very high durability and long life. Set of 2. 

Steel 8.4mm pivot balls hardened and ultra-precisely hand ground for very high durability and long life. Set of 2.  

Alu M10 adjusting nut for capturing pivot balls in front steering blocks and rear uprights. Set of 4. 

Molded composite ball cups for cushioning alu M10 alu adjusting nuts against 8.4mm pivot balls. Set of 8. 

M3x8 setscrew, hex drive. Set of 10 pieces. 

M3x8 button-head machine screw, hex drive. Set of 10 pieces. 

M3x14 button-head machine screw, hex drive. Set of 10 pieces. 

M3x8 flat-head machine screw, hex drive. Set of 10 pieces.
 

New high-speed ball-bearings manufactured specially for XRAY. ID x OD x thickness (mm) = 10x16x4. Set of 2 pieces.  

Silicone O-ring fits over 3mm shaft. 2mm thick. Set of 10 pieces.  

Polished chrome pin. Dia. x length = 2mm x 10mm. Set of 10 pieces.